At the end of this tutorial you should be able:
1) To connect the BMP180 Sensor and LCD to Arduino Uno
2) To compile and upload the source code
3) To display BMP Data on the LCD
HARDWARE:
1) Laptop
2) Arduino Uno Board
3) BMP180 Sensor
4) Breadboard
5) Jumper Wire
6) LCD
Please refer to your Manual on how to verify and upload code to Arduino Board.
You can download the source code using the link below:
https://drive.google.com/open?id=0B3cfm_LV09b5eDlnMjdRd1k3LUE